I had a work presentation at the Athens School of Fine Arts recently. Two of the works, T-Gyroid and Shell, are both produced by Shapeways. More information here. Check a video on YouTube and some images on Flickr.
Wow, :blush: Using Shapeways for an actual art exhibition ! I saw the shell when it came out of production. I really like it. It is very beautiful and graceful design. Kindly, Marleen
Thank you Marleen This presentation included previews works as well. I am planning to make my next one only with 3D prints. Of course, I will post here again when done, hopefully during 2010... Thanx again!
hello. how is the wall thicknes of the shell or th gyroid? i want to make larger objects (30 cm), but the price . i am privat not commercial. did you tested the minimal wall thickness? greet oliver
Hello Oliver The wall thickness of the shell is about 1mm. Same as the T-Gyroid model. I know exactly what you say, as I face the same problem each time I upload a model. I am trying to use 1mm wall thickness, also I try to make my models' surfaces look like a "grid" or any similar grid surface, just to keep the price down. However, whatever I tried on a 30cm model... gets immediately expensive...
thanks for the fast answer. ok, then i will make my bigger models with my old convential method . everything under 20 cm i will print here. here are my olders models. <a href="http://www.youtube.com/mindovermatter1973" target="_blank"></a> bye Oli