hellooooooooooo this is my current formula one project has been finished and it s ready for printing dimensions cm: 2.164 w x 1.454 d x 5.042 h in: 0.852 w x 0.572 d x 1.985 h
Looking at the dimensions of the overall model on the model page, I do not think you will get a successful print in any of the materials you have available for the model. What are the wall thicknesses for the front supension arms ( = wires) and the panels on the front wing? Paul [hr]stop4stuff Modeller for hireShapeways ShopTwitterYouTube[hr]
0.5mm for the front suspension arms would only be printable in Frosted Ultra Detail and then there's the probability that the model would not survive intact due to the mass that the thin parts need to support. Paul [hr]stop4stuff Modeller for hireShapeways ShopTwitterYouTube[hr]
0.7mm is the minimum for Strong & Flexible - even 1mm 'wire' is very flexible, for ridigity and printability in all but Ceramic, I'd be thinking somewhere up around the 1.5mm mark for the suspension wires and 1mm for the wings and rear under tray parts. Paul, [hr]stop4stuff Modeller for hireShapeways ShopTwitterYouTube[hr]