Sad Keanu comes in two sizes

Both are equally sad.

Teeny Keanu ($25) Little Keanu ($45)

---

Want to get both?

+

---

Cheer up, Little Keanu Reeves, it's ok. Just finish your sandwich and march on. Life is like a box of chocolate. Which pill will you choose? There is no spoon. You can't handle the truth! Wait. What was I doing again?

Make your own slide-on macro lens for the iPhone 4 or 4S. I designed this for my iPhone 4 when I couldn't find the image quality I wanted for less than $60.

Print this model and then buy the glass lens for $4 from Surplus Shed (http://www.surplusshed.com/). The Surplus Shed part number is L4471. For some reason the search box on the Surplus Shed home page does not work with part numbers. To get to L4471, use the "Lens Finder". In the Lens Finder type:

Lens Type: PCX, Plano Convex
Diameter: 12mm to 12mm
Focal length: 51mm to 51mm

It will get you to L4471

The lens fits in a recess in the model and is held in place with a few tiny drops of Superglue. If you get any glue on the lens it can cleaned off with nail polish remover or acetone. The lens is plano-convex (one side is flat). When inserted in the holder, the flat side of the lens faces the phone.

Note that the lens fits pretty snugly into the opening. Try fitting the lens before applying any glue. A good technique is, with the lens holder laying face-down on a table, lay the lens in position, and then push it into the recess by poking the lens with the eraser-end of a pencil. Once you know the lens fits cleanly, push it back out and put two tiny drops of superglue on opposite edges of the opening. I use a toothpick to apply the glue because squeezing the superglue directly out of the tube risks putting on too much. Then push the lens back in the same way as in the test fit.

The object pictures in the photo gallery (dime, ruler, and watch) are unedited and uncropped shots directly from my iPhone4.

This model will not slide over iPhone cases.

Accurate T.rex 1/144 scale

-BEST RESULTS is with White/Black Detail. more expensive, paintable. Detail is great!  Black Detail is best.
- White Strong and Flexible is cheap and paintable. Detail is pretty good.
-Colored versions of Strong and Flexible vary in quality.  

A long-range fire support mecha. This 2-piece model is 2.8cm tall when assembled.

Kit turns a Puzzle Cube into a Portal Companion Cube Puzzle

NOTE: This is just the white parts of the kit. Also buy Portal Puzzle KIt (1\2) for the whole set of parts


Instructions:
--Paint a Circle of Color on Each Side of Your Puzzle Cube (circle should be same size as black hoop part )

--Attach Corner parts using Super Glue

--Attach Edge parts using Super Glue (centering edges between corner parts)

--Attach Center parts using Super Glue (centering them in center square)

--Attach Black Hoop Parts using Super Glue (Center Parts with Edge Parts (Glue 100% of part to Cube or Hoops will fall off after next step)

--Carefully Dremel or Sand the Hoop Parts into 9 Sections Along Puzzle Cube Lines To Free the Puzzle Cube for Spinning/Solving\Un-Solving.



Thanks for your order and commitment to nerd culture!

Works for many doors. Key reads "13" in roman numerals on the 666 side & "7" when flipped to 777 side (via roman numeral subtratcion). Needle not included (too thin to reliably print). Has a small hole in end to accept needle or pin to complete the piece. Hole will vary with material choice & may need to be opened with small drill.