Construction instructions soon!. This kit is an evolution from a working prototype which I made several years ago with great results and potential. The features are not seen elsewhere and are unique, in that it utilizes a 3 field spinning disc and thermal to electricity generation.
This Kit only comprises the main structural 3D parts and requires further parts to make a fully completed model. Extras needed are (but are not limited to)
3 x aluminium 5mm x 200mm rod.
2 x aluminium tube 3/8" x 600mm.
3 x Peltzer Thermo electric ceramic pads 40mm x 40mm x 4mm.
6 x 10mm LED (Clear lenses) .
8 x 5mm drill stops.
6 x M3 brass screws 10mm to 12mm long.
4 x 10 or 12 mm dia x 5mm Neodynium N42 counter sunk North facing magnets (2.5KG pull).
4 x As above but South facing magnets.
6 x 15mm dia x 3mm thick Neodynium N42 (for outer edge disc centers spaced at 39.27mm apart giving 6 magnets).
4 x Bearings 10mm outter dia, 5mm inner dia and 4 to 5 mm deep/thickness.
5mm ground steel rod 300mm in length.
Components for SSG Bedini circuit.
Metal to Plastic glue.
5 x 2.5v 20F Capacitors in series (insulation tape).
3D Printed Parts required from this shop :
Part - Battery Housing x 1.
Part - Electronic Housing and Heat Sink x 1.
Coil Ends x 2 (x 2 of either Option 1 or Option 2).
Inner ring x 2.
Inner ring 40mm supports x 3.
Rotor disc x 1.
Axle Fixer x 1.
Bobbin x 1.