Shapeways + COVID-19  
See Solutions

Click and drag to rotate
SX350CRADELV3a1w Ridgesv9000 3d printed

Not a Photo

White Natural Versatile Plastic
SX350CRADELV3a1w Ridgesv9000 3d printed
SX350CRADELV3a1w Ridgesv9000 3d printed

Not a Photo

SX350CRADELV3a1w Ridgesv9000

Made by
3D printed in white nylon plastic with a matte finish and slight grainy feel.

Have a question about this product?

contact the designer
You must be logged in and verified to contact the designer.
Product Description

You just need to drill a 20 mm hole in the center of say a 1590B hammond box. Make sure the display is in the center of the hole and that you can see the active display completely. May need to move it some. Then use some RTV silicone to hold it in place. I use Insta-cure gap filling 1oz Bob Smith to glue the cradel in place make sure the glue is no going to get on the display. I would not put glue on the part that goes in the hole as it may creep out onto the finish. IF used in a Hammon 1590B box with two batteries you can get away with RTV or Hot gluing the board in the mount.  The batteries will hole it in place in the mod.  

What's in the box:
SX350CRADELV3a1w Ridgesv9000
2.36 x 4.54 x 1.47 cm
Switch to inches
0.93 x 1.79 x 0.58 inches
Switch to cm
Success Rate:
First To try.
What's this?
Mature audiences only.
Sign In or Join to comment.


We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.