Nintendo made this huge dock in order to avoid accidental falls if there were children around.
I decided it was way too big and want to showcase my device.
So I made it better. Sleeker, more compact and most importantly, portable.
You'll need to disasemble your original Nintendo Switch Dock in order to put electronical board in this model, i attached the instructions below, is really easy.
Here are a step by step instructions about how to disassemble your dock:
https://www.youtube.com/watch?v=tJ0lNjanHs8
Here are the files if you want to make it with your own 3d Printer, I give to the community under a Non commercial CC license:
.stl Files
Check reddit discusion board:
https://www.reddit.com/r/NintendoSwitch/comments/60pjqn/the_new_nintendo_switch_compact_dock/
Also appeared on Nintendo today!
http://nintendotoday.com/nintendo-switch-3d-printed-dock/
Version V1.2
- Adjusted the screw tolerances to put same than original dock, so you don't have to buy anything more.
- Adjusted general tolerances and some hole positions.