Shapeways + COVID-19  
See Solutions

Click and drag to rotate
A0 - A1 Reverser Columns and Pipes 3d printed

Not a Photo

Smooth Fine Detail Plastic
A0 - A1 Reverser Columns and Pipes 3d printed
A0 - A1 Reverser Columns and Pipes 3d printed

Not a Photo

A0 - A1 Reverser Columns and Pipes

Ships as soon as 5 days
3D printed in matte translucent plastic that showcases fine and intricate details.

Have a question about this product?

contact the designer
You must be logged in and verified to contact the designer.
Product Description
General A0 range overview.  Product descriptions below this...

The A0 is a 'what if' 4-6-2 Pacific locomotive design that was as far as we know drawn by Sir Nigel Gresley in 1915 and a couple of known redrafts afterwards.  A0 is not a real designation but for identification I coined it years ago when helping with the formation of two essays on the A0 and the possible development of it into other rebuild combinations.  I personally believe along with others that it may also form the basis of certain Railway Series characters.

For an in depth explanation of what the A0 is with photographs please check out the following link...
... and please also check out the aforementioned essay links WITHIN the link for a full understanding.

The wheelbase of the A0 1915 drawing is...
6'3" + 5' 3" + 7' 0" + 7' 0" + 8' 0" - However the Gresley A1 is...
6'3" + 5' 6" + 7' 3" + 7' 3" + 9' 6"

For this reason the SCC A0 range has been designed instead to fit the A1 wheelbase so they can still fit  RTR and kit chassis.'

The SCC A0's have been designed around three different Hornby Gresley A1's (bodies & chassis) to ensure as much compatability as possible between them.

What is offered is full locomotive body shells and also as another option the shells split down into kit components so you can combine them into various combinations yourself, even more combinations than the full shell options will be possible this way. 

For the kit route the parts will be easier to prepare and clean the surfaces for painting, also if you order just a running plate for example then you could use your own A1 body and cut out the relavant bits to fit the plates, used this way the items can be used for kit bashing purposes.

Certain configurations will require you changing cylinders and valve gear, or at least modifying them in various ways but the items in question will point you to the suggested changes in the product descriptions.

Product Description...

These are Right Hand Drive and a Left Hand Drive (RHD/LHD) Reverser Columns and pipes for the Gresley A1 Locomotive or the A0 - RHD/LHD Tapered Boilers.  The pipes can easily be made out of rod and split pins yet these have been made available upon request.

The A0 boilers have holes already in them so they should fit from the off, a little gentle hole opening may be needed though.  The A0 Taper Boilers already have the pipe housing designed on to the smokebox side so if using these pipes you can clip the duplicate off either the pipe or locomotive.

Important note.  These are only for the A1 boilers and not the A0 Parallel boilers.  Another for the those may be made later.
What's in the box:
A0 - A1 Reverser Columns and Pipes
11.94 x 1.28 x 1.54 cm
Switch to inches
4.7 x 0.5 x 0.61 inches
Switch to cm
Success Rate:
First To try.
What's this?
Mature audiences only.
Sign In or Join to comment.


We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.