Click and drag to rotate
JK Roll Cage w/ Light Bar Mount V2 3d printed

Not a Photo

Black Natural Versatile Plastic
JK Roll Cage w/ Light Bar Mount V2 3d printed
JK Roll Cage w/ Light Bar Mount V2 3d printed

Not a Photo

JK Roll Cage w/ Light Bar Mount V2

Made by
3D printed in black nylon plastic with a matte finish and slight grainy feel.

Have a question about this product?

contact the designer
You must be logged in and verified to contact the designer.
Product Description
V2 is the same dimensions as the original but has been updated with two tabs to mount an RC4WD hilift jack
& I also slightly redesigned the light bar mounts.

Roll cage for the ever popular china 2drJK body, it mounts in the same spots that the factory hard top does when you take it off.
Here's the hardware sizes needed to mount it.
Front(over the windshield):
 2.5x6mm(outside where the the factory hardtop mounts) & one 2x6mm button/round head screw & nut in the middle.
Middle(main hoop):
2.5x16mm cap head screw & washer
Rear(down bars):
2.5x12mm cap head screw & washer

Attaching it to the JK body, I find it best to remove the windshield frame from the body & bolt it to the roll bar then reassemble the unit back onto the body & the bolt the rear section on in a diamond pattern(ie: corner to corner) one more thing of note, you'll need to gently squeeze the middle part of the frame over the windshield to get it to line up with the exsiting hole in the top of the windshield frame.
What's in the box:
JK Roll Cage V4.1 w/ Light Bar
17.5 x 22.94 x 6.69 cm
Switch to inches
6.89 x 9.03 x 2.63 inches
Switch to cm
Success Rate:
First To try.
What's this?
Mature audiences only.


We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.