This model is part #dg007 of my Full-sized Dalek Gun-stick and is an optional plug for electronics with space for multiple stacked 12mm batteries, speaker, teensy 3.1 (or similar development board) and 26 through-holes for wiring. Designed to fit inside standar 1.5" pipe used for making handle (standard vaccum extension reccommended).
My Dalek Gun-stick is a screen-accurate replica of the Dalek gun-stick (featured in s9, ep1&2) of Doctor Who, weilded by Missy, Clara Oswald and the 12th Doctor. It is designed with an in-built universal joint so it can move about and this would be VERY useful for building a full-sized Dalek as well.
#dg001: The tip of the barrel has internal recesses cut, allowing for up to 8x 5mm LEDs to be affixed at the correct angle for maximum lighting-FX.
#dg002: The base of the barrel is set with correctly sized/ angled holes allowing them to be set with plastique or metal tubing that has been pre-bent, allowing for easy addition of outer tubes of the barrel.
#dg003: The inside part of the barrel-base is set with bolt-holes for securing the outer-base to a hollow 100mm (4” ball) while also providing an additional base, pre-set for electronics with 5mm divots set at a focal angle centred on main-barrel of the gun-stick. This allows for the addition of extra, high-powered LEDs or even Lasers.
#dg004: This cup is the female-end of a ball-joint created by modifying a hollow 100mm “contact-juggling” ball. It is set with holes for adding 10 blue 5mm LEDs, wires/tubes, set-screws (for securing to the main handle tube (standard vacuum-hose extension is recommended).
#dg005: Is the upper part of the bottom of the handle (pommel) and has holes for feeding wires/tubes, and is female-threaded and matched to the lower portion of the pommel.
#dg006: Is the lower portion of the pommel and is male-threaded and matched to the upper portion, allowing for easy access to batteries and electronics in the handle.
#dg007 is the electronics plug, which is fit to plug directly into the main handle, and accommodate a number of electronic effects.
Other parts required:
100mm (4”) hollow contact-juggling ball
2cm (od) aluminium pipe
25m of 2mm (od) aluminium tubing
standard vacuum-hose extension
8x, 5mm LEDs (green and blue mix)
10x, 5mm LEDs (blue or blue/red)
Teensy 3.1 development board (or similarly sized)
12mm 3V batteries
High-output LED relay
Silver “rub ’n buff”
Clear gloss spray-paint