This bridge was designed for the Phantom 4
to carry payload, such as lights, cameras, etc.
The center hole is made for a 1/4" screw to mount cameras
Screws can get ordered at https://www.amazon.de/MENGS-Schraube-Edelstahl-Einbeinstativ-Schnellwechselplatte/dp/B00IXDECV4/ref=pd_sim_421_5?_encoding=UTF8&psc=1&refRID=1GJV2T2Q8TTXAMB66AWT
The 4 outside holes are to mount a camera mount with 4 dampers. If you do so please secure the camera mount with 2 cable binders through the center hole.
The dampers should fit a 7mm hole.
Dampers can get ordered at https://www.dronematters.com/rubber-damper-s-black-526.html
There is a simple camaera mount available at:
and a camera mount for 360 cameras (those should hang lower) at:
Last but not least also order the O-Ring at:
A sample video with the Samsung Gear 360 is attached below. In this video a shorter Camera Mount was used. So using the mount above will make the drone smaller.
To see the video in 360 mode you either need a Chome browser or a browser on a mobile device capable to play 360° videos.
Attention: Flying with Payload changes the flying behavior of your Phantom 4. Avoid windy conditions when flying with payload. Also avoid fast movements. Plan for longer descent times. Always fly carefully!
Overloading your Phantom can lead to overheating the engines and fast battery drain.
Using these designs the pilot carries the full risk for all potential damages. The designer can not be held accountable for any damage caused by the usage of these designs.