1/144 Scale DKM Prinz Eugen Barrels 20.3 cm/60 (8") SK C/34 x8. This set DOES NOT contain the Turrets. See My Shop for Turret Set for this kit: http://shpws.me/OOfj
20.3 cm/60 (8") SK C/34
- 8x Accurately sized 20.3 cm/60 (8") SK C/34 Barrels.
- Printed with pivot for 1/144 Turret set
This was the only 20.3 cm (8") weapon ever designed by Germany and was quite powerful with a long range. Two of the turrets intended for the uncompleted Seydlitz were mounted as coastal artillery on Ile De Croix. It had been intended to mount the other two at Ile de Ré, but this apparently never took place.
These guns are probably best known for when Prinz Eugen started the Boat Deck fire on HMS Hood shortly before her loss.
Four of these guns came into Soviet service when the Germans sold the uncompleted heavy cruiser Lützow to the USSR in 1940. Renamed Petropavlovsk, only turrets A and D were operational during her early career and she fired 676 rounds in defense of Leningrad. Badly damaged and sunk in shallow water on 17 September 1941, she was later repaired during 1942 with three working 20.3 cm guns. She fired over 1,000 rounds during the Leningrad breakout in January 1944. Renamed Tallin on 1 September 1944. The Soviets were also interested in purchasing the uncompleted heavy cruiser Seydlitz but this was vetoed by Hitler in 1939.
At the end of World War II, the Prinz Eugen was allocated to the USA. Before being sent to the nuclear tests in the Pacific, her "A" turret guns were removed at the Philadelphia Navy Yard in Pennsylvania and these were then sent to the Naval Weapons Facility at Dahlgren, Virginia, for testing. They remain there on permanent display
Constructed of loose barrel, an inner and outer jacket, a breech end-piece screwed hot on to the outer jacket and a breech block supporting piece pushed into the breech end-piece and held by a threaded ring. The loose barrel was removable from the rear and would fit any gun. The breech block was a horizontal sliding type and was hydraulically operated.
Actual bore diameter was 20.30 cm (7.992").
Some part cleanup will be necessary. The 3D printing process uses a waxy substance to support certain part features during the printing process. Although the parts are cleaned by Shapeways, some waxy residue may remain. It can be safely removed with water and a mild aqueous detergent like "Simple Green" using an old, soft toothbrush, Q-tips or pipe cleaners. During the printing process, liquid resin is cured by ultraviolet light. Microscopic bits of resin may remain uncured.
Let your parts sit in direct sunlight for a few hours to fully cure the resin.
Water-based acrylic paints meant for plastics is strongly recommended.
Other paints, especially enamels, may not cure on Frosted Detail 3D-printed plastics.
Use dedicated model sprue cutters to remove parts to minimise the risk of damage to parts.
Please take a look at my other items.
Painting tips and preparation