You must be logged in and verified to contact the designer.
This is a replacement arm for the CW01 double wishbone front end. It fits either side.
This is the heavy duty wide or 8mm offset front arm. The version pictured is a reinforced arm that has a thin, 2mm wall throught the center of the arm and requires a 2mm rod to be inserted throught the pivot point and glued in place. The hole will need to be cleaned out using a 2mm drill bit before inserting the rod.
There is no denying that the Lunchbox and Midnight Pumpkin are two of the most iconic RC cars ever. All the wheelie popping fun never tires! Now you can upgrade your CW01 to have double wishbone front suspension! All without a single modification to the chassis. AMPro's CW01 front end will allow you to install new a-arms, uprights and a central pivot to existing screw holes. Just add an upper threaded link and you are all set! This is a 8mm per side offset front end, perfect for racing and jumping. The zero offset version is also available. Please remember to clean all holes with a 3mm drill bit to prevent binding. Mounts for threaded ball ends are designed for M3 screw diameters.
*IMPORTANT NOTE* The CW01 chassis has large tires that add more stress to this front suspension. It is not recommended that you run anything other than the stock silver can motor. A hard impact will break this front end. This is not intended for anything other than a very light runner. We are not responsible for broken parts, nor is Shapeways unless there is a defect in the print. This is a fun simple upgrade for your CW01 but please understand that this front end is not as strong as the orginal and should not be used for bashing of any kind at all.
Video of installation and running can be found here: