7 Chambers AniFlex V2 Crystal Chassis Emitter P3

Chassis for the 7 Chambers Aniflex V2 style hilts.
This is a permanent wired in battery design, not removable.

For this chassis you will also require P2 & P1 of the design
This chassis is designed for use with:
-Proffie Board
-KR Sabers 28mm Bass speaker
-18650 Lithium Ion Battery
-2.1mm x 5.5mm recharge port
-Crystal or my generic chassis crystal (found on shapeways) and single neo pixel
-Shtok Short Pin Hilt side LED PCB (most likely requires sanding down on the outside diameter)

The crystal neopixel requires gluing into the crystal once everything is wired up and tested, and then the crystal requires gluing into the chamber once everything is wired up and tested.
The crystal chamber required gluing onto the main body when ready and wired through. 
The chassis is design for the board to slide into position once tested. We recommend this as the final step. 

Handle with care.
Any damage occurred during installation is the responsibility of the individual installer.