Product Description The "Adaptive Rig System" is designed for Gopro Hero4 (or Hero3) that have been modified to receive a super wide angle lens(between 190-Degree and 220-Degree for best results)
The "Adaptive Rig System" is modular. Once mounted in the "Camera cages", the Gopro cameras can be installed either on the 3, 4 or 6-camera base(2 and 8 camera bases in preparation, prototypes available for printing at Shapeways on special request).
The "6-camera Rig with cover" presented here is composed of:
-one 3d-printed camera base (6-cam configuration)
-Six 3d-printed camera cages
-A cover set("Dual Rig Cover Kit")
Gopro cameras and cables shown on pictures are not included
Screws and nuts needed to assemble the 6-camera rig (External Ebay links provided):
-3mm/M3x0.5 - Socket Head Cap screws - 30mm long
- Qty needed 18 (3 per camera)
-3mm/M3x0.5 - Hex Nuts
- Qty needed 30 (5 per camera)
-3mm/M3x0.5 - Flat Head Socket screws countersunk - 12mm long
- Qty needed 12 (2 per camera)
Already modified Gopro cameras can be bought directly from Peau Productions
Otherwise DIY lens installation can be done easily on stock Gopro cameras.
Many videos are available on Youtube to show the lens replacement
(See also this step-by-step instructions
220-degree lenses can be purchased from Peau Productions
190-degree lenses can be found on Aliexpress
The 6-camera configuration with Gopro Hero4 Black edition can achieve a video ouput resolution of up to 6K per eye in 3D(Stereoscopic) at 30fps. Photo resolution up to 3k x 6k.
In 2D mode(monoscopic), comparable resolutions can be achieved with the benefit of ample overlap between cameras, allowing more precise stitching.
All rigs have a 1/4" hole clearance in the center, for tripod or grip mounting.
The camera cages have been designed to allow good heat dissipation and an access to all buttons and connectors, including the rear 30-pin bus connector, that can be used to power the cameras from an external source, via a Battery Eliminator cable
The "Dual Rig Cover Kit
" is composed of:
-one cover box
-one cover lid
Thanks to a reversible lid and a special pattern at the bottom of the box, the "Dual Rig Cover kit" can receive a "6-Camera Rig" or a "4-Camera Rig".
Once the box is closed , the Rig is protected from external shocks and can be safely transported with no risk to damage the cameras and the lenses.
The "Dual Rig Cover Kit" will fit nicely in a hard case with customizable foam
Screws and Nuts suggested for the Box and Lid(External Ebay links provided):
-1/4-20 Hex Cap Bolts
- 3/4" long - Qty needed between 2 and 6
-1/4-20 Knurled Thumb Nuts
- 3/8" long - Qty needed between 2 and 6