Click and drag to rotate
7mm - LB&SCR E2 - 0 Chassis 3d printed

DIGITAL PREVIEW
Not a Photo

White Natural Versatile Plastic
7mm - LB&SCR E2  - 0 Chassis 3d printed
7mm - LB&SCR E2  - 0 Chassis 3d printed

DIGITAL PREVIEW
Not a Photo

7mm - LB&SCR E2 - 0 Chassis

Print With Shapeways
Choose Your Material
$106.61
Choose your color and finish
QTY

Have a question about this product?

contact the designer
You must be logged in and verified to contact the designer.
Product Description
The dummy hornblocks have 'etched' lines cut into them to aid a saw should you wish to remove these and add real brass sprung hornblocks in their place.  If using a FUD chassis the chassis will be weak until the replacement hornblocks are properly installed.  Chassis more readily set up for springing are being worked on as a future development.

If building the original / standard E2 then 1-2mm of material will have to be filed off the front of the chassis frames as the later versions were 3 inches longer here.

The axle holes are 4.8mm's and will need reaming slightly to accept bearings/bushes. 

The brake pads are already in position for the wheels, the brake rodding iwill ned to be made from brass rodding or similar.

A spacer is sprue joined to the side of the chassis and needs to be added inside the frames where ever you choose.  The choice depends on what gearbox you are using and the sapace it takes up.  If using a gearbox thinner than the space provided then thickening the frames with some thin plastic will make everything flush.


The chassis joines to the body by slotting the rear protrusion into the space on the body then angling the whole chassis upwards, if it is a little tight then filing in the recesses will alleviate this.  The  hole at the front is for fitting to the body, a bolt is reccomended, you don't need to add a nut to the top as it will self tap easily in both WSF and FUD and can easily take repeated handelling, however, a space inside the smokebox saddle on the body is provided should you wish to add a nut.  If the hole is a little tight then drilling or reaming it out to a wider diametre is fine. 
Details
What's in the box:
7mm - LB&SCR E2 - 0 Chassis
Dimensions:
4.63 x 20.58 x 3.24 cm
Switch to inches
1.82 x 8.1 x 1.28 inches
Switch to cm
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.