You must be logged in and verified to contact the designer.
Product Description
Chassis for the KR x OR Emperor hilts.
This is a removable battery design. The battery tabs required are the type shown in the link below:
https://www.ebay.co.uk/itm/20Pairs-18650-Battery-Negative-to-Positive-Conversion-Spring-Contact-16-5mmx16mm/362591431441?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649
For this chassis you will also require P1 of the design.
This chassis is designed for use with:
-Proffie Board
-KR Sabers 24mm Bass speaker
-18350 Lithium Ion Battery
-Shtok Short Pin Hilt side LED PCB (most likely requires sanding down on the outside diameter)
- High amp kill switch
-Crystal or my generic chassis crystal (found on shapeways) and single neo pixel
-18650 battery tabs (see link above for type required)
The kill switch requires gluing in to place once everything is wired up and tested. We recommend a dab of hot glue to secure it.
The chassis is designed to be fully removable from the hilt, and retained by the pommel.
Handle with care.
Any damage occurred during installation is the responsibility of the individual installer.
We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers: