Click and drag to rotate
Custom housing for Focusrite Scarlett 2i2 2nd gen 3d printed

DIGITAL PREVIEW
Not a Photo

Custom housing for Focusrite Scarlett 2i2 2nd gen 3d printed
Custom housing for Focusrite Scarlett 2i2 2nd gen 3d printed

DIGITAL PREVIEW
Not a Photo

Custom housing for Focusrite Scarlett 2i2 2nd gen 3d printed
Custom housing for Focusrite Scarlett 2i2 2nd gen 3d printed

DIGITAL PREVIEW
Not a Photo

Custom housing for Focusrite Scarlett 2i2 2nd gen 3d printed
Custom housing for Focusrite Scarlett 2i2 2nd gen 3d printed

DIGITAL PREVIEW
Not a Photo

Custom housing for Focusrite Scarlett 2i2 2nd gen

Made by
$98.27
3D printed in white nylon plastic with a matte finish and slight grainy feel.
QTY

Have a question about this product?

contact the designer
You must be logged in and verified to contact the designer.
Product Description
Have you got a Focusrite Scarlett 2i2 2nd gen audio interface, but you don't like the red brushed aluminium housing? This might help you! You can order a 3D-printed housing in various different colors to fit your studio. A custom logo or text can be requested at order. A logo must be black and white. The black will be cut into any of the 4 sides on whatever position you want. The cut will be either 0.15 or 0.3 mm deep. That's up to you.

Installation:
  1. Carefully peel the rubber feet on the rear bottom of your Focusrite Scarlett 2i2 2nd gen to expose the mounting bolts. Only these two bolts hold the interface in the housing. Use a phillips screwdriver to remove the bolts.
  2. Carfully slide the interface out the front of the housing.
  3. Slide the interface into the new housing in the same orientation (the ridge on the inside of the housing is the front side and the mounting holes should be at the bottom).
  4. Use the original bolts to secure the interface inside it's new housing.
  5. Carefully peel the rubber feet off of the original housing and stick them on the bottom of the new housing. Keep in mind that both feet have a flat underside on one end and on the other end, there's a nudge that sticks out the bottom. This nudge is supposed to go inside the bit of the bolt. You might need some double sided tape to properly secure the feet to the new housing as it leaves some glue behind when peeled off.
Request a custom order and get this product personalized just for you
Details
What's in the box:
Custom housing for Focusrite Scarlett 2i2 2nd gen
Dimensions:
17.5 x 4.5 x 9.9 cm
Switch to inches
6.89 x 1.77 x 3.9 inches
Switch to cm
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.