1/700 Scale French AMX 13 75 Light Tanks.
Contains 10 highly detailed tanks.
AMX 13 75 Light Tank
- 10x French AMX 13 75 Light Tanks
The AMX-13 is a French light tank produced from 1953 to 1985 (The AMX 13 75 version was produced until 1966.
). It served with the French Army and was exported to over twenty-five other nations. Named after its initial weight of 13 tonnes, and featuring a tough and reliable chassis, it was fitted with an oscillating turret built by GIAT Industries (now Nexter) with revolver type magazines which was also used on the Austrian SK-105 Kürassier. Including prototypes and export versions there are over a hundred variants including self-propelled gun, anti-aircraft systems, APCs, and ATGM versions. Sporting a modified version of the Panther's 7.5 cm KwK 42 L/70 gun with dual 6 round autoloading magazines, it allowed a quick succession of shots. However, it could not be reloaded from within the vehicle and required disengaging from contact, finding cover for the crew to dismount and reload, then re-engaging the enemy. Total production of the AMX-13 family is approximately 7,700 units, around 3,400 of which were exported.
The tank was designed at the Atelier de Construction d'Issy-les-Moulineaux in 1946 to meet a requirement for an air-portable vehicle to support paratroopers, the first prototype ran from 1948. The compact chassis had torsion bar suspension with five road-wheels and two return rollers; the engine runs the length of the tank on the right side with the driver on the left. It features an uncommon two-part oscillating turret where the gun is fixed to the turret and the entire upper turret changes elevation. The turret is set to the rear of the vehicle and holds the commander and gunner. The original 75 mm gun, allegedly modelled on the German 7.5 cm KwK 42 L/70 gun (used, among others, in the Panther tank) but firing very different ammunition from a shorter barrel, was fed with an automatic loading system in two six-round magazines located in the turret's bustle. The twelve rounds available in the loaders meant that the crew could engage targets quickly, however once those rounds were expended the vehicle had to retreat to cover and the crew reload them from outside the vehicle. Production began at ARE (Atelier de Construction Roanne) from 1952, with the first tanks delivered the following year. In 1964 production was transferred to Creusot-Loire at Chalon-sur-Saône, as the ARE moved to building the AMX 30 MBT, and the numbers produced declined significantly.
Some part cleanup will be necessary. The 3D printing process uses a waxy substance to support certain part features during the printing process. Although the parts are cleaned by Shapeways, some waxy residue may remain. It can be safely removed with water and a mild aqueous detergent like "Simple Green" using an old, soft toothbrush, Q-tips or pipe cleaners. During the printing process, liquid resin is cured by ultraviolet light. Microscopic bits of resin may remain uncured.
Let your parts sit in direct sunlight for a few hours to fully cure the resin.
Water-based acrylic paints meant for plastics is strongly recommended. Other paints, especially enamels, may not cure on Frosted Detail 3D-printed plastics.
Use dedicated model sprue cutters to remove parts to minimise the risk of damage to parts.
Please take a look at my other items.
Painting tips and preparation