1/128 Scale DKM 15cm/48 (5.9") Tbts KC/36T Gun x1. This is a highly detailed part based on plans and photographs to make these the most accurate DKM 15cm/48 (5.9") Tbts KC/36T Gun available (these aren't the old 3D Models lifted from the German Naval Guns book as these are quite inaccurate/low detail, also the dimensions given for this mounting this book are quite incorrect). This is the later war version with vent on Turret Roof. See My Shop for early war version.
- 1x Mounting
- Highly detailed, accurate parts, modelled from plans and photographic reference.
- Barrel can be angled as desired (-10º to +65º)
- Details include Hex nuts, Exterior Steps, Ships Shield on Turret wall, Crew Guide Rails, Doors, Sighting Ports and Casing Ejection Ports.
This was a "Torpedo Boat Cannon" used on the German "Narvik" class destroyers (Type 36A and Type 36A Mod).
Although this was a powerful gun for a destroyer, it had a slow rate of fire for a destroyer weapon and was really not suitable for such a small ship. The heavy weight of the shells was also a problem as the gun mountings lacked power assist, meaning that the shells had to be manually fed into the breech. As these guns were used primarily in open mountings, bad weather greatly hampered their operation.
When these destroyers were modified to carry a twin mount forward, the additional bow weight caused them to become very "wet" ships. However, these problems were somewhat offset by the fact that the twin mount was fully enclosed and had a high maximum elevation, thus allowing for limited use against aircraft.
Construction differed from other German 15 cm guns in that the loose barrel could be changed from the muzzle end and that the breech opened horizontally. Other than that, the design was similar to other guns in this caliber and consisted of jacket, loose barrel, breech piece and semi-automatic breech that was opened manually to load the first round. The KC/36 was used in single mountings while the KC/36T was used in twin mountings. The KC/36T had a breech weight in order to move the center of gravity towards the rear, which gave a more compact gunhouse and lower trunnion height while still being able to achieve higher elevations.
The 15 cm (5.9") was the standard caliber used on most German capital ships and cruisers since the turn of the century. The capital ships used this gun size as their secondary weapons whereas the light cruisers and the "Narvik" class destroyers had these as their main weapons.
All German 15 cm guns had an actual bore diameter of 14.91 cm (5.87 in).
Some part cleanup will be necessary. The 3D printing process uses a waxy substance to support certain part features during the printing process. Although the parts are cleaned by Shapeways, some waxy residue may remain. It can be safely removed with water and a mild aqueous detergent like "Simple Green" using an old, soft toothbrush, Q-tips or pipe cleaners. During the printing process, liquid resin is cured by ultraviolet light. Microscopic bits of resin may remain uncured.
Let your parts sit in direct sunlight for a few hours to fully cure the resin.
Water-based acrylic paints meant for plastics is strongly recommended. Other paints, especially enamels, may not cure on Frosted Detail 3D-printed plastics.
Use dedicated model sprue cutters to remove parts to minimise the risk of damage to parts.
Please take a look at my other items.
Painting tips and preparation