This is a custom built curtain panel glider. This part is great if you want to covert your Version 1( panels slide off ends of curtain rail) Kvartal into a Version 2 (Snap-on curtain panels). I built this because it was a pain in the butt having to remove my curtain for cleaning. The Version 1 panels you have to slide off the end of the curtain rail which is impossible if its installed close to a wall. In this scenario you would have to remove the entire rail system. With this modification you can just snap the panels right off/on without having to run them off the end of the rail.
Compatible with part:
This part has been printed, tested, and fits prexisting Ikea parts perfectly but be aware that 3D printed parts have a +/- tolerance of about .1mm so you might have to clean out some small holes with a toothpick or pin. Also areas with tight fits might need to be slightly filed or sanded. Nothing that takes more than a few seconds of work.
Need a part we don't have in our Shapeways store, don't worry we'll make it for you. Just fill out the "Part Request Form
" at http://petesparts.infinitediscounts.com/
and your request will automatically be emailed to us.
Be sure to check out other parts we have in the shop by clicking IKEA Replacement Parts