Eaglemoss Ecto-1 GB Proton Pack Hose Connectors

I hate the way the hoses are laid out on this pack.  Especially how the long blue hose wraps around the top.  It doesn't.  There are 3 missing details on the the Ion Arm that I just had to have on my pack.  A long Run-Thru Connector on the inside of the arm that the hose runs thru.  A Nut Connector on the top of the arm the the blue hose fits onto, and finally a Resistor Connector on the outside of the arm.  To fix this, I cut the long blue hose about 1/2 inch from the end.  I painted the cut off piece yellow (because it's a yellow wire).  I connected the hose to the bottom pin and then glued the Resistor Connector to the outside of the arm.  I glued the other end of the short piece into the connector at the bottom.  Next, I connected the long part of the hose to the pack pin as normal.  I glued the long Run-Thru Connector to the inside of the arm and threaded the hose thru it.  The Nut Connector I painted brass and glued to the top of the arm, then glued the hose into the Nut.  See pics below for details.  TADA... a much better looks then what was provided and looks so much better!  I modeled these connectors to help you detail out your packs.  I've included 4 sets of these 3 connectors for your build.  I hope you all like them.  Lemme know what you think!

What you get on 1 sprued part:
     4 - Run-Thru Connectors
     4 - Nut Connectors
     4 - Resistor Connectors

For more information about this and other detail parts, you can join my facebook group here:  Satyr's Models