A
SRH-771 EzUHF Tx Antenna Holder that clamps onto the Handle of the Taranis X9D thus allowing the Antenna to be positioned at a different angle when used in combination with a JR Module.
Not included in the purchase but necessary is a
SMA 200mm RG316 Extension Cable, four M3x6 Screws ( I used Discovery Frame Screws ) and four M3 Nuts.
Preparation & Installation:- Separate the 4 Pieces from each other and remove the sprue pieces that held them together.
- Sandwich the Extension Cable between the two smaller Halves.
- Insert the assembled Cable into the Main Body until it's flush - The inside of the Main Body has a hexagonal area into which the hexagonal part of the Cable must go preventing it from turning later on.
- Sandwich the Handle of the Remote between the Main Body and the Front Plate - This may take some force as it will lock all 4 pieces together.
- Use the Nuts and Screws to tighten everything together - Use moderation when doing so and don't try to close the Gap between the two Large pieces.