You must be logged in and verified to contact the designer.
This wing blade represents a single lift ten foot long version, drivers side. Once assembled it will raise and lower, and rotate upwards, as well as swing outwards. CARE needs to be taken to remove all the parts from the main sprue, and test fit each piece. Pay attention to the assembly picture in this description. The hinges are primarily the dimple/pocket type and careful sanding of each to get them to fit into place, without falling out is going to be necessary. the pin that goes in the blade itself that makes it rotate will need to be sure and free of glue to round swivel. Insert pin through round swivel, put just a little tad bit of glue on end of pin, then put in blade, allowing a little free movement. I cannot guarantee that the movement of all the pieces works perfectly, and fair warning that there may be some minor modifications necessary for perfectly smooth operation. Should there be a problem or question, contact me via the designer link or direct via email to firstname.lastname@example.org