Click and drag to rotate
AA Mount V5 3d printed

Not a Photo

White Natural Versatile Plastic
AA Mount V5 3d printed
AA Mount V5 3d printed

Not a Photo

AA Mount V5

Made by
3D printed in white nylon plastic with a matte finish and slight grainy feel.

Have a question about this product?

contact the designer
You must be logged in and verified to contact the designer.
Product Description
Mini-z front single piece suspension bulkhead for double-A-arm suspension parts. A-arm front track width reduced by 0.3mm on both sides to better suit the available tie-bars. Holes need finalizing for correct sizes (1.5mm, 2.0mm, and ~1.7mm for threaded M2 screws). It will fit MR03 and MR03VE with the same modfications as a standard PN Racing double A-arm. It does require the other parts of a standard MR02/MR03 double-A-arm front end. The fitment of the parts cannot be guaranteed, but have been tested on track. This version has a level upper arm with 0 degrees of reactive caster angle. The upper axle has room for a shim to fine tune caster. This part will simplify the tuning of the front end of a double A-arm front end and remove much of the unwanted play in parts fitment. Parts probably will need fine tuning for best fit and slack-free operation.
What's in the box:
AA Mount V5
4.34 x 1.44 x 1.78 cm
Switch to inches
1.71 x 0.57 x 0.7 inches
Switch to cm
Success Rate:
First To try.
What's this?
Mature audiences only.


We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.