You must be logged in and verified to contact the designer.
This is a custom spacer for your Transformers Power of the Primes Voyager Figures Elita 1 and Starscream. This adds additional tension to the hip joint of the cimbiner, making them firmer and allowing them to stand more solidly.
This is sold as a set of 2 pieces connected together. You will need to cut separate them and cut off the excess plastic
To install, unscrew the torso assembly. You can either remove the pin in the torso to get access to all the screws or unscrew the visible screws and gently pry the halves apart to free the shoulder joint. Replace the factory part with the 3D print replacement. Line everything back up and screw together.
This is intended for adult figure collectors. This is not designed for rough play by children.
This was printed and tested on my home 3D printer with SLA plastic. Depending on the plastic you choose, sanding or polish may be needed to fine tune the fit.