Atom Sabers Even Piell Proffie Chassis P1

Chassis for the AtomSabers Master EP (Even Piell) hilts.
This is a permanent wired in battery design, not removable from chassis.

For this chassis you will also require P2, P3 & P4 of the design.

This chassis is designed for use with:
-Proffie Board
-Two metal 4x4x1.5mm SMD tactile switches
-KR Sabers 24mm Bass speaker
-16650 Lithium Ion Battery
-2.1mm x 5.5mm PCB laptop style recharge port (rectangular front)
-Shtok neopixel PCB connector set (most likely requires sanding down on the outside diameter)
-Shtok Short Pin Hilt side LED PCB (most likely requires sanding down on the outside diameter) 

When installing the blade side PCB holder inside the hilt, if uses the brass decor screw on the hilt to retain it. Do not over tighten this screw otherwise you could risk breaking the PCB holder. Just turn it until you feel if grab the pcb holder.
The recharge port requires gluing in to place once everything is wired up and tested. We recommend a dab of hot glue to secure it.
The switches require gluing to the chassis are being wired up. 
Since there is not room inside this hilt for my usual board retention design, there is a groove for 5mm Kapton tape to retain the board

Handle with care.
Any damage occurred during installation is the responsibility of the individual installer.