You must be logged in and verified to contact the designer.
One 100mm diameter round base. Perfect for monsters, robots, or vehicles. Contains a disk to be secured to the underside of the base which is numbered from 1 to 16 to track wounds or damage to the model. No more dice next to your models!
NOTE: Some assembly required and a cyanoacrylate glue is recommended. Always test-fit before assembly. While you do want some friction to keep the disk from spinning freely, too much may prevent it from turning at all. Due to minute imperfections in printing, you may need to lightly sand the edges of the disk if the fit is too tight. When assembling, be sure to only apply glue to where the peg on the under side of the main base will contact the cap piece. Be careful not to glue the rotating tracker disk in place! You will only need a small amount of glue and excess glue may seep out and end up adhering to the rotating disk. The cap is designed to account for some excess, but when it comes to super glue you don't need much. "A little dab'll do ya."