Click and drag to rotate
1/64 8" 32' Inline Drive Grain Auger, Electric 3d printed

Not a Photo

Smooth Fine Detail Plastic
1/64 8" 32' Inline Drive Grain Auger, Electric 3d printed
1/64 8" 32' Inline Drive Grain Auger, Electric 3d printed

Not a Photo

1/64 8" 32' Inline Drive Grain Auger, Electric

3D printed in matte translucent plastic that showcases fine and intricate details.

Have a question about this product?

contact the designer
You must be logged in and verified to contact the designer.
Product Description
This is a 1/64 8" 32' grain auger. It is an electric inline drive auger. Almost everything is inlcuded in this kit to build the auger. You will need some wire for the pivot points. I use jewelry head pins to keep the wheels on the carriage. Assembly is not too difficult if you have experience with this type of work. Assembly should be straight forward. Look up pictures of an 8"x32' Mayrath auger for more guidance.

Due to the nature of the product, pieces may be warped. To fix this, run part under hot water and slowly bend. Do not bend too much or pieces will break. This may take several attempts. Be patient and you can eventually fix them.

For mounting the two halves of the carriage, I glued wire into the small holes on both sides of the upper chassis (the half that the tires do NOT mount on). Then spread the bottom chassis apart to allow pins to slide into pivot holes. 

I glued a small strip of styrene on the track once assembled to keep chassis from falling off track. Comes with 2 different spouts. 

Auger wants to tip when lowered down. It may be beneficial to insert a small metal rod in the bottom half of the auger to keep the auger from tipping. 

The electric drive shield should have two locator holes. The hole that is centered toward the bottom mounts on the small stub sticking out on the auger gearbox. The hole in the top corner of the shield is for the shaft on the electic motor. Looking at the auger with the hopper closest to you, the motor goes on the right side. The motor included is a 7.5 HP motor.

NOTE: I will get actual pictures of the finished product at a later date.
What's in the box:
8 32 Mayrath Electric
4.1 x 12.63 x 1.97 cm
Switch to inches
1.61 x 4.97 x 0.78 inches
Switch to cm
Success Rate:
First To try.
What's this?
Mature audiences only.
Sign In or Join to comment.


We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.