You must be logged in and verified to contact the designer.
This X Brace is intended for use with the Modular Mods sold in this shop and is offered for those without metal fabricating tools. Besides being a strengthening structure at the base of the Cage Print the X Brace also locks in the Circuit board prints, Battery Chambers and Charging Panel prints in place in the Cage Print with four M3 screws. This X Brace is also an electrical conductor to bring the negative pole of the batteries/battery into the housing of the Modular Mods. The center hole of the X Brace has been sized to allow for 1/4-20 threading to be tapped into it which will tighten the clearance around the D-ring screw.. The hole on the center of the X brace can also be drilled to allow the threads of the D-ring screw to pass through. A 1/4-20 brass thread insert should be soldered to the interior side of the X Brace as shown in the accompanied pictures above. All safety measures, precautions and electrical calculations should be addressed and utilized in the fabrication of this product. Your safety is your responsibility.