You must be logged in and verified to contact the designer.
This chassis kit is designed to help you easily build a magracing chassis to fit your existing 1/32 scale, mid-large model car body. Fits most 1/32 accurately scaled models of closed-wheeled full size cars with a typical body profile having a wheelbase from 106" to 124". It will NOT fit most LMP race car bodies. Kit requires other parts to complete. CK2 is similar to CK5 with the following significant differences: 1. CK5 has a slightly thinner side profile which reduces the amount of interior that might have to be removed for the chassis to fit the body. 2. CK5 has a battery compartment that must be loaded from the top which requires removal of the body. 3. CK5 uses bronze strip for battery contacts instead of magnets. 4. CK5 can navigate slightly tighter corners. 5. CK5 has a minimum wheelbase of 3.25" compared to 3.30" for CK3.
Features of CK2 include the following:
Adjustable wheelbase from 3.30” to 3.90” compared to standard magracing chassis with fixed wheelbase of 3.0”. If you need a shorter wheelbase you should consider Chassis Kit CK1. If you need a chassis for an LMP body, you should consider Chassis Kit CK3 which employs an inline motor configuration where the motor shaft runs perpendicular to the rear axle.
1 degree of positive toe and 2 degrees of negative camber improve handling and lane changing.
Shorter front suspension beams allow for narrower front track, compared to original magracer chassis.
Accommodates shorter rear track too !
Fits more bodies with cockpit intact due to thinner profile compared to original magracer chassis.
Adjustable motor mount makes meshing gears easy.
Accommodates protected and unprotected 10440 rechargable batteries.
Does not require removal of body to change battery.
Use bronze spring strip or magnets for electrical connectors at battery terminals. Bronze strip elliminates need to remove any insulation from the battery. Bronze strip also takes up less space leaving more space for cockpit and air vents.
Weighs less than original stock chassis.
Use with steering coil, printed circuit board, battery, motor, pinion gear, and some of the screws, nuts and magnets of a standard magracing chassis which you already have. Designed to be used with 3/32" diameter front and rear axles, along with wheels, and tires typically used on 1/32 slot cars.
Purchase a few other screws and magnets separately from MagRacingUnlimited, or others.