Revised 6/26/16 for DNA75 LED slot; added more surface area for epoxy.
Mounting plate for mounting the DNA250 / DNA200 / DNA75 board + screen inside the case x5 mounting plates.
Remove the supports with a pair of nippers, then remove the bumpies left from cutting the support off with a craft knife.
Requires 3x #0 screws per mounting plate to mount the board to the plate.
Insert the screen through the plate's slot from the back side of the plate to the front, slide screen to the top edge of the screen guide (if the screen doesn't stay put, apply a piece of double-sided tape to the underside of the screen), tuck entire cable under plate, screw the board to the plate.
To seat the mounting plate flush with the inside wall of the case, use button actuators with a 1mm thick flange (all my DNA button sets have a 1mm thick flange).
Either epoxy the plate to the inside wall of the case, or purchase 3x #0-80 12.7mm long screws with a nut for each mounting plate, insert the screws through the front of the case to the back of the board, attach the nut (must drill holes in the case that align with the screws of the DNA250 / DNA200 / DNA75 board).
See also DNA250 / DNA200 / DNA75 - Companion Template for cutting holes in the case.