Click and drag to rotate
Pitot tube holder (RVJET) 3d printed

DIGITAL PREVIEW
Not a Photo

Pitot tube holder (RVJET) 3d printed
Pitot tube holder (RVJET) 3d printed

DIGITAL PREVIEW
Not a Photo

Pitot tube holder (RVJET)

$19.49
3D printed in white nylon plastic with a matte finish and slight grainy feel.
QTY

Have a question about this product?

contact the designer
You must be logged in and verified to contact the designer.
Product Description
Pitot tube holder designed to fit the DIYdrones, Rangevideo and Eagletree etc pitot tube. It is two parts that is glued together. It is designed some extra tolerances because some pitot tubes are thicker and have glue on them etc. For installation in EPO foam use a 10mm sharp drill and make an elongated hole. The pitot tube is glued in place. For optimal performance make sure the tube is placed in a free airflow unaffected by the airframes boundary layer. The picture below show an early version that has later been improved. It was designed for the RVJET but can be used on most foam models.
Details
What's in the box:
Pitot tube holder (RVJET)
Dimensions:
7.74 x 0.5 x 6.82 cm
Switch to inches
3.05 x 0.2 x 2.68 inches
Switch to cm
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.