You must be logged in and verified to contact the designer.
A stronger servo-saver linkage and receiver part for the vintage Tamiya Wild Willy M38 kit 5835.
Both linkage parts printed as one and connected by a sprue.
Due to print tolerances, the bore hole diameter may need to be increased slightly with a drill bit. I'd rather the print be tight and bored to loosen than to print too loose. On these vintage cars I have seen the steering shaft worn and looser on some cars than on others - thus the design for a tight fit. When installed on your car, make sure the parts can move on the shaft and aren't "stuck" in place.