You must be logged in and verified to contact the designer.
Product Description
A set of 20 round posts to make a cable barrier system for your custom magracing or slotracing track.
Looks great and helps prevent cars from ending up in the weeds!
Posts are .25" x .875" tall, like 8" x 28" wooden posts at 1/32 scale.
Each post has pin .375" long attached to bottom of post for easy installation.
Piano/music wire can be used as cable with posts. Wire diameter of .025" (.6mm) to .032" (.8mm) works fine.
Can also be used with monofilament fishing line, or preformed 3 x 7 hollow core, braided stainless steel wire, with 0.031" diameter, which won't unravel when cut.
Similar to BP2-11 which has 9 tall posts and 2 short posts.
Installation Instructions
Separate posts from sprue using sharp knife, razor saw, or hacksaw blade.
Paint posts if desired.
Where you want the posts located, drill holes in baseboard of track slightlly larger than diameter of pin, if baseboard is hard like MDF. Make holes smaller, if baseboard is soft like XPS rigid foam insulation board. Space holes about 3" apart.
About 1.75" from the location of the post at each end, start a small screw in the baseboard which will be used to anchor the ends of both cables to the baseboard at each end.
Clean out all holes in posts with proper size drill bit and then slide both pieces of wire through both holes in all of the posts.
Wrap the end of both cables around one of the screws and draw down the screw as needed.
Put a dab of thick glue in the holes and press the posts into the baseboard.
Wrap the other end of the 2 cables around the other screw and draw down the screw as needed.
Before glue sets, straighten up the posts if needed
When glue is cured, enjoy your cable barrier system that is both attractive and functional.
We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers: