Wannawanga Grip Cutting Guide-2.0 Accurate

For when you purchase uncut grips this guide will help you cut them down to a uniform size. Whether going for A New Hope, The Empire Strikes Back or The Force Awakens this guide will allow you to mark on your grips to cut them to precisely 92mm long. It is recommended to use a dremel or other hand held tool along with masking tape or painters tape to hold the grips in the template.

For ESB and TFA grips there is a notch cutting guide along with a marker to show where to drill the hole for your rivets or screws. On one end there is a 30 degree angled hole so you can shave the ends correctly and uniformly for A New Hope installs.

PLEASE NOTE: This was designed specifically for 13.3mm wide hard plastic grips from Wannawanga. While it may find success with other grips this has not been tested to work at this point. It is designed to create a 10mm notch, 10mm from the bottom of the hilt. This matches the layout of the grips included in the Parks/Korbanth Graflex 2.0 kit.