You must be logged in and verified to contact the designer.
Replace those broken Megami Device shoulder joints! This is a 4 pack of replacement shoulder joints for Megami Device Model Kits. I tested this design at home using my 3D printer with PLA filament. Simply Cut the joint from the sprue and adjust as needed. You may need to sand this if it is too big or doesnt fit right. You can tighten up ball joint using a light coating of a plastic-friendly paint, epoxy, enamel etc.
This is intended for adult model kit collectors/builders. This is not designed for rough play by children.
Depending on the plastic you choose, sanding or polish may be needed to fine tune the fit.