You must be logged in and verified to contact the designer.
This center component is part of an Electromagnet base designed to hold and display your Infinity Orbs. You need three of these flaps, one central bit, and 3 end caps to assemble the entire Electromagnet base. I tried uploaded all of the parts into one 'product' for Shapeways to print, but they insisted the parts were too big to go together as a single listing, so I had to divide it up like this. Assembly should be straightforward - the flaps each have hinge pins that lay in the channels on the central piece. These pins are sandwiched between the top and bottom halves of the center, which is glued together to hold the flaps on. The end caps are then inserted into the holes at the ends for show.