Mic hangers for "lostsheep" Toyota Tacoma mounts
Made by
Print With Shapeways
Choose Your Material
Choose your color and finish
Choose Your Material
$31.71
Choose your color and finish
Have a question about this product?
contact the designerYou must be logged in and verified to contact the designer.
Product Description
This is a pair of CB/Ham radio microphone hangers designed specifically to mate with Lostsheep's 2nd-generation Toyota Tacoma threaded accessory mounts as found on Tacomaworld. Please note these will NOT fit the revived accessory mount by Coop68.
The mic hanger bolts in to the bottom two threaded points using half-inch-long 1/4"-20 socket cap screws. I used these from Fastenal. While the hangers could be installed on either side, the mic button cradle is intended to point outboard to leave as much access as possible to the climate controls. When attached to the bottom two mount points, the topmost mount point is left available for a RAM ball or any other 1/4"-20 threaded accessory to be installed concurrently with this mic hanger.
The tolerances on the bolt holes are very tight - thread the screws in, and alternate top and bottom to tighten the screws to the mount.
The mic hanger bolts in to the bottom two threaded points using half-inch-long 1/4"-20 socket cap screws. I used these from Fastenal. While the hangers could be installed on either side, the mic button cradle is intended to point outboard to leave as much access as possible to the climate controls. When attached to the bottom two mount points, the topmost mount point is left available for a RAM ball or any other 1/4"-20 threaded accessory to be installed concurrently with this mic hanger.
The tolerances on the bolt holes are very tight - thread the screws in, and alternate top and bottom to tighten the screws to the mount.
Details
What's in the box:
mic hanger mk2 both
Dimensions:
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
