1/32 Fly Porsche 908 Chassis fits Slot.it SW Pod

Always check out our main page for the latest updates in the store : Click Here
Full Classic Fly Starter Kit available at our online store: Click Here

Fly Porsche 908 Slot Car Chassis

• Limited lifetime guarantee - if it breaks, Changing Gearz will replace it!!!
• Light weight and strong
• Accepts Slot.it Sidewinder motor pod (CH68, CH64, CH62 etc)
• Accepts 2mm axle height adjusters on front axle (SCC rounded 2mm or slot.it 2mm)
• Accepts Slot.it axle bushings (CH56) for front axle (optional)
• Front end cross member for strength
• Dynamic ribbing to control chassis flex
• Strengthened body mount pads
• Motor wire stays molded in
• Fits all Fly Porsche 908/2 models (not Flunder, not 908/3, not 917 etc)
• Minor cockpit trimming required for proper fit

 

Compatible Fly 908 & 908/2 Cars
Steps:
Install CGin3D chassis on to body without motor pod (so you can clearly see interior of the 908)

With a marker - draw a line in the region shown in red ~ from the motor pod mounting hole toward the rear.

Cut away material

Install motor pod on chassis and test fit chassis to car. Trim as required.

 



A notch needs to be trimmed into the rear detail piece. It should clear the motor pod if you would like the motor pod to float