Stripes is a 3D printed bracelet for your iPod Nano 6 gen. This bracelet will make your iPod Nano 6 looks more stylish and protects your iPod against impacts. Stripes also has a functional physical buttons to give you access to your iPod's volume and power buttons. The material used for this bracelet is the strong-flexible plastics that has become the most favorite material used in 3D prints.
This bracelet is suitable for a Medium sized wrist (5,8 cm w x 3,45 cm h).
Other size :
Small (5,4 cm x 3,3 cm)
Medium ( 5,8 cm x 3,45 cm)
Large (6,1 cm x 3,7 cm)
Not sure what size are you? Hold a ruler on the bottom of your wrist for knowing the width, and the side for the height. It is recommended to select the bracelet size that is a little loose to your wrist. This to avoid uncomfortable tightness around your wrist. Example : If your wrist's size is 5,6 cm x 3,3 cm, select the medium sized one (5,8 cm x 3,45 cm) instead the small one. You might want to check the picture I provided for a clearer explanation.
Please note that this model is still under improvement. It might have a flaw because I haven't printed it and tested it myself. And I apologize for the high price. I have tried reducing unnecessary volume to reduce cost but it still a bit expensive, and I only take a very small profit from this.
If you want to support this project, you could print this bracelet and/or give me a feedback on how I can improve this project in the future. Thanks a lot guys, and enjoy your new iPod bracelet!