The Great Smoky Mountains are a part of the Blue Ridge Mountains, themselves a region of
the Appalachian Mountains, running nearly the length of the East Coast of the US.
Half a million acres in North Carolina and Tennessee were set aside eighty years ago
to form Great Smoky Mountains National Park, and the park is now is the most-visited
in the National Park Service system.
This model covers 83 square miles of the Central Smokies just south of Gatlinburg,
containing US Route 441 over the Newfound Gap,
nearby Mount Le Conte, and Clingman's Dome, the highest peak in the park.
Mt. Mitchell in North Carolina is the highest mountain in the Eastern USA, but
is only 40' higher than Clingman's Done, and all three are over 300' higher than
Mt. Washington in New Hampshire, at 6288'.
Though not studded with alpine peaks like many of our other models, this
piece carefully captures the countless ridges and ravines blanketing the range,
amounting to a texture unique to this remarkable place.
Model scale is 1:48700
Model covers an area approximately 9.1 by 9.1 miles
Altitudes covered: 1585' to 6643'
There is never any vertical exaggeration in TinyMtn models.
Click here for more sizes.
Click here for other 12" models.
TinyMtn models are most affordable in the "White Strong and Flexible" and "Sandstone" materials. This model is in "White Strong and Flexible." When you receive the model, there may still be Nylon dust on it from the printing process. Use either an airbrush, canned dust blower, or a soft old toothbrush to remove this dust. Do not get the "White Strong and Flexible" material wet, and don't prime it or use any oil-based paints on it. You can safely seal it with Polycrylic or a similar water-based clear spray sealant. Read more about this popular material here.
The "Frosted Detail" material will show more detail, but is semi-transparent and has an uneven surface texture when unpainted (due to the orientation of the model when Shapeways prints it). It may show up feeling a little greasy and with small crystals in crevasses. Clean those off by soaking the model in warm (but not hot) soapy water and brushing with an old toothbrush. To get the surface to an even matte finish, spray with a few light coats of sandable primer (white automotive primer works), and then do a baking soda grit-blast.
These models have been optimized for the above materials, and are not offered in other materials for strength or cost reasons. If you need one in another material, please contact us and we'll try to accommodate your request.
(C) 2014 TinyMtn (TM)
Model created using GDAL, NetPBM, Gmsh, Carve, MeshLab, and other custom software
Source of digital elevation data: U.S. Geological Survey
The USGS home page is http://www.usgs.gov/