Six generic 1/25 scale pre-drilled distributors in 3 different heights. Designed for 26-30 gauge wire. Holes may need to be opened slightly with a pin drill for ignition wires to fit, depending on wire gauge and insulation thickness. Designed for V8 engines.
These distributors are each about 4.2mm in diameter.
//Update March 10, 2019: Based on feedback and test prints, the holes have been enlarged to fit a .48mm OD wire, so common 1/25 ignition detail wire products (IE Detail Master) should fit without modification.
If you experience problems fitting wire into the Version 1 distributors, we suggest shaving the end of the wire very slightly (not enough to strip it) in order to taper it, allowing the wire to slide into the hole for a firm press-fit.
Finally, apologies for the price increase, this is due to Shapeways' pricing updates and out of our control.