This part is specifically designed for my new Port Side Wall. Is the outer corridor ring, floor grill and wall light! Reason it's in a different material is that because of the details it cannot be printed in a lower quality material. This set works with both my ANH and ESB version of the Port Wall. The only difference is that ANH doesn't use the light. You can get my ESB Port Side Wall here:
You can get the ANH Port Side Wall here:
Included are 3 parts (attached by a sprue for resin printing)
- 1 Outer Corridor Ring
- 1 Floor Grill (goes in the hole below the corridor ring)
- 1 Electrical Room Wall Light (glues over the hole near the electrical room, a 3mm white LED with round end sanded flat fits into that hole - ESB Version Only!)
This is a complete detail for that entire wall. I don't have the PE ring or TonyRR's rings to compare, but this was specfically designed to fit the wall perfectly. Thanks to Dragse7en and Bluevoice for their teamwork in getting these together!
(UPDATE 7/19/16: Repaired weak sprue issue)