This chassis employs two 21700 batteries so you'll want to wire them in parallel to keep the voltage at the required input voltage for Proffie (if you go series, voltage is additive so you'd need a voltage converter).
Alternatively, you can wire this with only one battery if desired. Just skip one slot and proceed as usual.
Proffie board also sits at an angle for ease of access, the angle is 20 degrees. Use the following in your config for this
#define ORIENTATION_ROTATION 0,20,0
Parts are as follows:
- Proffie v2.2
- 2x
21700 KeepPower protected button top batteries
-
Keystone Battery tabs
-
28mm bass speaker
- 17.5mm OD pixel connector (Shtok NPXLv3 or Cantina/CCSabers)
-
3A Kill Switch
- Omron B3FS-1000 switch or the
red ones