1/160 (N) German Pz. Kpfw II Ausf J Reconnaissance Tank x1.
Highly detailed tank with moveable Turret and accurate Track detail.
Comes in 4 parts: Hull, Turret and Wheels/Tracks for both sides. Some assembly will be required.
1x Pz. Kpfw II Ausf J Reconnaissance Tank
Pz. Kpfw II Ausf J
Continued development of the reconnaissance tank concept led to the much up-armored Panzer II Ausf. J, which used the same concept as the Pz.Kpfw. IF of the same period, under the experimental designation VK 1601. Heavier armor was added, bringing protection up to 80 mm on the front and 50 mm to the sides and rear, with 25 mm roof and floor plates, increasing total weight to 18 tonnes. Equipped with the same Maybach HL45P as the Pz.Kpfw. IF, top speed was reduced to 31 km/h. Primary armament was the 2 cm KwK 38 L/55 gun. 22 were produced by MAN between April and December 1942, and seven were issued to the 12th Panzer Division on the Eastern Front.
Some part cleanup will be necessary. The 3D printing process uses a waxy substance to support certain part features during the printing process. Although the parts are cleaned by Shapeways, some waxy residue may remain. It can be safely removed with water and a mild aqueous detergent like "Simple Green" using an old, soft toothbrush, Q-tips or pipe cleaners. During the printing process, liquid resin is cured by ultraviolet light. Microscopic bits of resin may remain uncured.
Let your parts sit in direct sunlight for a few hours to fully cure the resin.
Water-based acrylic paints meant for plastics is strongly recommended. Other paints, especially enamels, may not cure on Frosted Detail 3D-printed plastics.
Use dedicated model sprue cutters to remove parts to minimise the risk of damage to parts.
Please take a look at my other items.
Painting tips and preparation