1/150 Scale Imperial German Navy SMS Nassau or SMS Westfalen 28cm/45 (11") SK L/45 Guns x6. Highly detailed parts, created from plans and many reference photos. Parts have been printed to minimise wax support contact and maximise detail.
- Set Contains 6 Turrets and 12 separately printed Barrels that can be elevated as desired
- 6x DrL C/06 Turrets (Shorter) in All positions (Fore and Aft have Large Rangefinder at rear of Turret).
See renders for correct placement
- Rivets, Hex Bolts, Vents, Shell Disposal Ports, Sighting Ports and Blast Bag Fasteners
These guns were used to arm Germany's first "Dreadnought" type battleships and battlecruisers. The battlecruiser Von der Tann
used these weapons to sink HMS Indefatigable at the Battle of Jutland (Skagerrak).
During World War II these guns were used only as coastal artillery. They were then supplied with a lighter shell with a larger propellant charge for increased range.
Constructed of A tube, two layers of hoops and a jacket. Used the Krupp horizontal sliding wedge breech block.
All German 28 cm guns had an actual bore diameter of 28.3 cm (11.1").
Some part cleanup will be necessary. The 3D printing process uses a waxy substance to support certain part features during the printing process. Although the parts are cleaned by Shapeways, some waxy residue may remain. It can be safely removed with water and a mild aqueous detergent like "Simple Green" using an old, soft toothbrush, Q-tips or pipe cleaners. During the printing process, liquid resin is cured by ultraviolet light. Microscopic bits of resin may remain uncured.
Let your parts sit in direct sunlight for a few hours to fully cure the resin.
Water-based acrylic paints meant for plastics is strongly recommended. Other paints, especially enamels, may not cure on Frosted Detail 3D-printed plastics.
Use dedicated model sprue cutters to remove parts to minimise the risk of damage to parts.
Please take a look at my other items.
Painting tips and preparation