You must be logged in and verified to contact the designer.
This is a version of my dark fairy wing, it is a good size for Msd and yosd. These are edited to be more affordable so they are thinner, and a little smaller etc then the original wings. Make sure to grab both the right and left wings, and you will need 4 magnets, the hole for the magnet is about 8.5 mm in diameter and width, so I reccomend getting these: https://www.kjmagnetics.com/proddetail.asp?prod=D55-N52
The material does shrink about 1mm when 3d printedYou can use a dremel or sand paper to widen the hole if too snug.