Click and drag to rotate
(1:144) Messerschmitt Me P.1109 (Single Wing) 3d printed

Not a Photo

White Natural Versatile Plastic
(1:144) Messerschmitt Me P.1109 (Single Wing) 3d printed
(1:144) Messerschmitt Me P.1109 (Single Wing) 3d printed

Not a Photo

(1:144) Messerschmitt Me P.1109 (Single Wing)

3D printed in white nylon plastic with a matte finish and slight grainy feel.

Have a question about this product?

contact the designer
You must be logged in and verified to contact the designer.
Product Description
Source : "A Summary Of A Half-Century of Oblique Wing Research" by Michael Hirschberg. (Page 3)

This project number is not entirely certain, as the original document is damaged and barely readable. This was a further development of Dr. Vogt's work on the BV P.202 dated July 15, 1944, and was similar in that the sweep of the wings could be varied to improve low-speed flight characteristics. There were two variable-sweep wings, one above and one below the fuselage. Two He S 011 turbojets were mounted in nacelles and were located on each side of the fuselage. Apparently, this design was the subject of some further development after the war, according to some sketches discovered in France, but it is not known whether this was done by Messerschmitt or some other firm.
What's in the box:
1109 hs
3.95 x 8.31 x 1.6 cm
Switch to inches
1.56 x 3.27 x 0.63 inches
Switch to cm
Success Rate:
First To try.
What's this?
Mature audiences only.


We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.