Click and drag to rotate
1:8 BTTF DeLorean Radio Heatsink 3d printed

DIGITAL PREVIEW
Not a Photo

1:8 BTTF DeLorean Radio Heatsink 3d printed
1:8 BTTF DeLorean Radio Heatsink 3d printed

DIGITAL PREVIEW
Not a Photo

1:8 BTTF DeLorean Radio Heatsink 3d printed
1:8 BTTF DeLorean Radio Heatsink 3d printed

DIGITAL PREVIEW
Not a Photo

1:8 BTTF DeLorean Radio Heatsink 3d printed
1:8 BTTF DeLorean Radio Heatsink 3d printed

DIGITAL PREVIEW
Not a Photo

1:8 BTTF DeLorean Radio Heatsink 3d printed
1:8 BTTF DeLorean Radio Heatsink 3d printed

DIGITAL PREVIEW
Not a Photo

1:8 BTTF DeLorean Radio Heatsink 3d printed
1:8 BTTF DeLorean Radio Heatsink 3d printed

DIGITAL PREVIEW
Not a Photo

1:8 BTTF DeLorean Radio Heatsink 3d printed
1:8 BTTF DeLorean Radio Heatsink 3d printed

DIGITAL PREVIEW
Not a Photo

1:8 BTTF DeLorean Radio Heatsink

Made by
$15.50
3D printed in matte translucent plastic that showcases incredibly fine and intricate details.
QTY

Have a question about this product?

contact the designer
You must be logged in and verified to contact the designer.
Product Description
This is a 1:8 scale replica of the original heatsink that sits on top of the radio on the dashboard on the Back to the Future A-car DeLorean. Replaces part 42H. Specially designed for the 1:8 scale Eaglemoss DeLorean model.  

The design was made to be used with 0.28mm diameter wire, that's half as thin as the stock ones in order to preserve accuracy. 

Fully tested in order to make sure it fits perfectly. Only available in the highest resolution possible, because of the small details.

Paint instructions
Prime the parts with Tamiya grey primer. Paint the electronics board (the base where the heatsink is placed on) with Vallejo Pale green (71095). Paint the outer most resistors with black, then the front side of the circuit board (the one facing the front of the car) with Vallejo Brass (70801). Also use Vallejo Brass with one drop of black to paint the central resistor. 

The heatsink itself can be painted with Vallejo steel  (71065) and the top part of the central transistor (the one where the wires attach to) with black.

Assembly
After installing the wire you can glue the heatsink on top of the green circuit board. Then just clip the circuit board into the dedicated holes in the radio. No screwing required. 

 
Details
What's in the box:
Radio_heatsink_revF
Dimensions:
2.9 x 1.57 x 0.63 cm
Switch to inches
1.14 x 0.62 x 0.25 inches
Switch to cm
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
Sign In or Join to comment.
 
 
Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.