You must be logged in and verified to contact the designer.
This is a hollow replica. The hole in the top has a cap (seen to the right in the photo) that you simply put into place with a little glue. Since it is hollow it will print for much lower price now. You can fill up the hollow interior with plaster or and other 2 part mix solidifying material to give it some weight and added strength. Just don't use any material that exotherms too hot.
Paint with Createx Opaque Purple #5202 http://www.tcpglobal.com/itemdetail.aspx?ItemNo=CRE+5202-2Z
This is the same paint used on the show.
Add yellow florescent paint to the engravings to simulate the glowing effect. After painting with purple, clear coat with acrylic clear http://www.tcpglobal.com/spraypaintdepot/crystal-clear-acrylic.aspx
Then you will be able to paint in the engravings and wipe away the excess with a damp rag and not effect the purple base coat.
This can also be done in reverse. Paint the fluorescent yellow in the engravings, then use the sponge dab technique to apply the purple. Makeup sponges work great. Dab the sponge in purple and then dab the paint onto the model. May take 3 coats.
Before painting, it is important to wash the oil off the surface. There is also going to be a very fine powder in the engravings. Use COLD running water and a small soft brush to pick out the caked in powder in the engravings. It is really fine and tends to get in tight in the inside corners. The oil will come off with dish detergent liquid soap. Remember the 3d print is fragile so handle with care while cleaning or painting.
For best results, please order Frosted Ultra Detail.
White Strong and Flexible may not be printable, but if you would like to try, there is no risk to you. It might just delay your order.
With Frosted ultra detail, the material reacts to heat, so keep it cool. If you experience the large flat faces are not perfectly flat this is very easy to fix. Fill a small pan with water that is 160 deg. F and let the model sit flat in the water. When the water has naturally cooled to room temperature, the model will be flat again and hold its shape.